Welding Procedure Specification Smaw

Welding Procedure Specification Smaw

Welding, Level 1: Trainee Guide


Welding, Level 1: Trainee Guide

This exceptionally produced trainee guide features a highly illustrated design, technical hints and tips from industry experts, review questions and a whole lot more Key content includes Welding Safety, Oxyfuel Cutting, Plasma Arc Cutting, Air Carbon Arc Cutting and Gouging, Base Metal Preparation, Weld Quality, SMAW – Equipment and Safety, Shielded Metal Arc Electrodes, SMAW – Beads and Fillet Welds, Joint Fit-Up and Alignment, SMAW – Groove Welds and Backing, and SMAW – Open V-Groove Welds.

$103.03

Fatigue Design Procedure for Welded Hollow Section Joints


Fatigue Design Procedure for Welded Hollow Section Joints

This International Institute of Welding (IIW) report was presented at the 52nd Annual Assembly in Lisbon in June 1999. It contains recommendations representing a consensus on international best practice, focusing on a ‘hot spot stress’ approach. A wide range of joint types is covered, the new fatigue design curve for both RHS and CHS is dealt with and detailed values for stress concentration factors are provided. The purpose of this current IIW document is to serve both as an International Standards Organisation (ISO) draft specification and as a model standard for national and regional specifications worldwide. The Recommendations (Part one) and Commentary (Part two) were edited by Dr X-L Zhao of Monash University, Australia and Professor J A Packer of the University of Toronto, Canada.

$265

Welding Level 1 Trainee Guide, Paperback


Welding Level 1 Trainee Guide, Paperback

This exceptionally produced trainee guide features a highly illustrated design, technical hints and tips from industry experts, review questions and a whole lot more Key content includes Welding Safety, Oxyfuel Cutting, Plasma Arc Cutting, Air Carbon Arc Cutting and Gouging, Base Metal Preparation, Weld Quality, SMAW – Equipment and Safety, Shielded Metal Arc Electrodes, SMAW – Beads and Fillet Welds, Joint Fit-Up and Alignment, SMAW – Groove Welds and Backing, and SMAW – Open V-Groove Welds.

$99.68

How to setup welding test plates (1 inch plate with backup bar for certification tests)

Welding Procedure Specification Smaw

Leave a Reply